Tronstol 3V (Standard) Pick and Place Machine with Simple hand solder stencil printer and Small Reflow Oven - Economical Assembly Production Line SMT Electronics Machinery.
Tronstol 3V (Standard) Pick and Place Machine with Simple hand solder stencil printer and Small Reflow Oven - Economical Assembly Production Line SMT Electronics Machinery.
Simple hand solder stencil printer mainly suitable for some simple PCB boards, it is only suitable for single-sided boards. This is a very cost-effective product.
1) Install screw lever, wire clip, fixed block and counterweight lever in sequence according to the graphic presentation above.
2) Rotate counterweight lever while adjusting tight nut.
1) Put steel stencil printer in the wire clip, and tighten the steel stencil by its handwheel.
2) Put the simple DIY positioner on the printing table and also put the PCB accordingly. Adjust the five-star handle on the operation platform to make the holes on PCB match the holes on the steel stencil.
Tronstol 3V (Standard) is an economical pick and place machine, which maximizes labor savings and improves work efficiency. This is a desktop pick and place machine.
It is so easy to operate which is your best choice for sample production.
You can click to know Pick and Place Machine Tronstol 3V Standard Specification & Features.
The T962A is a micro processor controlled reflow-oven. It can be used for effectively soldering various SMD and BGA components.
The whole soldering process can be completed automatically and it is very easy to use. This machine uses a powerful infrared emission and circulation of the hot air flow, so the temperature is being kept very accurate and evenly distributed.
A windowed drawer is designed to hold the work-piece, and allows safe soldering techniques and the manipulation of SMD/BAG and other small electronic parts mounted on a PCB assembly. The T962A may be used to automatically rework solder to correct bad solder joints, remove/replace bad components and complete small engineering models or prototypes.
1) A large infrared soldering area
Drawer panel area: 300*320mm; this increases the usage range of this machine drastically and makes it an economical investment.
2) Choice of different soldering cycles
Parameters of eight soldering cycles are predefined and the entire soldering process can be completed automatically from Preheat, Soak and Reflow through to cool down.
3) Special heat up and temperature equalization with all designs Uses up to 1500 Watts of energy efficient Infrared heating and air circulation to reflow oven.
4) Ergonomic design, practical and easily operated
Good build quality but at the same time, lightweight and a small footprint allow the T962A to be easily bench positioned transported, or stored.
5) a Large number of available functions
The T962A can solder most boss-eyed or double-face PCB boards small parts, for example, CHIP, SOP, PLCC, QFP, BGA, etc. It is the ideal rework solution from single runs to on-demand small batch production.